Can you name the
Tools ?
S-10 Drum Brake
Removal of return spring
#1,
Adjuster
lever
1
Guide plate # 2
2
Remove Hold down
Springs, The short
one goes with
adjuster lever
Remove
adjuster
lever and
return
spring , note
pivot
bushing# 3
3
Note position of parking brake strut rod and
anti –rattle spring #4
4
Strut for parking brake
with the anti rattle
spring
Note curve and
wide end on strut
Note alignment of parking
brake lever
Remove hold down from
short shoe
Remove shoesas aunit careful of the
adjuster spring # 5
5
Remove adjuster #6
with out stretching of
spring #5
6
5
A clean layout will help you with
assembly
Removal of parking brake lever
from cable
Inspect wheel cylinder for leaks and
free movement of pistons
Note wear on backing plate and
lube with proper brake grease
Reassemble Clean,
No grease or dirt on
hands or brake
friction material!
Place holdown pin in pivot bushing to
hold adjuster lever in place
With care not to stretch spring attach
primary shoe with adjuster spring
Attach primary shoe with
care not to stretch adjuster
spring
Hold Down spring
Hold pin from rear and turn in
with a half twist of tool to lock
Spring
Narrow slot goes towards primary shoe
Tool is not needed to
place the adjuster
rod
Replace return
springs with
care not to over
stretch
Insert adjuster
return spring with
small end up. Note
position of adjuster
#7
7
Almost perfect!
Replace primary return spring
and note guide plate clearance
Inspect what you expect!!!
Use a safety Set tool
to pre adjust shoes
Set measurement to
drum first
Replace drum and check for
noise and shoe adjustment
Thanks to the
Morning Zoo Crew
Leaders,
Andy and Tim